Operation
39
Operating manual TEMPAR console V9.0
626140-9149-911
3.2.16
"Configuration > System > Connections” menu
Fig. 36:
"Connections" step
A connection to a TEMPAR cockpit can be made under "
Cockpit
".
– Enter the IP address of the TEMPAR cockpit with which the connection
is to be made, under "Cockpit IP”.
– Enter the API password of the TEMPAR cockpit with which the
connection is to be made, under "API password”. The API Password
can be read off in the TEMPAR cockpit under Configuration > Cockpit
> Linked Consoles > Consoles > API.
– Press the "Save” key.
– Press "Test connection” to determine whether connection to the
cockpit is possible.
A connection from a client cockpit to a master cockpit is also possible. If
TEMPAR systems that are connected to the client cockpit are also
connected to the master cockpit, then each of the TEMPAR systems of
the client cockpit must be created again on the master cockpit (see
TEMPAR cockpit operating instructions).
There is normally no need to make any settings in the "
Management
Interface
" area unless you are instructed to do so by a ZEISS employee.
Clicking on “Test connection” causes a test to be performed on whether
the Management Interface can be reached with the current settings. If
this is the case, online updates can also be used.
