Zehnder Rittling 40019309, Руководство по эксплуатации

Страница: 35 / 149

64
40019121
5.3 Advanced parameter setting for remote control
WARNING"
Access to parameter setting is possible only when the remote control is off.
Some parameters on your remote control can be adjusted according to how you use it.
mode
boost
mode
boost
mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode
mode
%DFNWR
previous
parameter.
Go to
the next
parameter.
Parameter
number
Parameter
value
No Parameter Description Default
setting Setting
0
Duration
of Boost
operation Adjustable from 15 to 120 minutes in 15 minute steps 60
Press the + or - key
1
Window
open
detection Value 0 (function disabled) or 1 (function enabled) 1
Press the + or - key
2
Eco
temperature Value 0 (eco temperature unlinked) or 1 (linked eco-
temperature setting: comfort T° minus 3.5°) 1
Press the + or - key
Press on P1P2 and
mode for 2 seconds
to enter.
WARNING
"
It is essential to get
WRWKH¿QDO³(QG´VFUHHQ
WRFRQ¿UP\RXUSDUDPHWHU
changes.
mode
boost
2
seconds
mode
boos
$IWHUQRNH\KDVEHHQSUHVVHGIRU
65
02/2019
No Parameter Description Default
setting Setting
3
Pilot wire Value 0 (pilot wire disabled) or 1 (pilot wire enabled) 1
Press the + or - key
4
Ambient
temperature
calibration Adjustable from -5.0°C to 5.0°C in 0.5°C steps 0.0
Press the
+
or
-
key
5
Selection of
temperature
sensor Value 1 (receiver unit) or 2 (remote control)
See chapter 5.4 1 or 2 Press the + or - key
6
None --
7
Re-pairing
radio-
frequency
Value 0 (unpaired command) or 1 (paired command) rF0 or rF1 Press on
+
or
-
key to
re-pair an appliance
which was
previously
paired
but has lost the
link.
8
Default
display Value 0 (time) or 1 (temperature setting) 1
Press the + or - key
9
Display
version
number and
reset (unpai-
ring).
Back to factory settings
Warning!
All your settings as well as the pairing, will be deleted.
If the remote control was paired before the reset,
the receiver unit will also be reset.
x.xx Press on
+
key for
10
seconds
to reset.
End
Display para-
meter setting
output Quit the settings menu
Short press on
mode or for 2
seconds on .
$IWHUQRNH\KDVEHHQSUHVVHGIRU
one minute , the remote control will automatically
quit the advanced parameters and turn off.
Reset Version number