EM-0146-8
- -
60
7.1.2 Warnings
When the probability of the failure of the ASE pump unit is determined, warnings are displayed
before alarm output.
Take appropriate measures in the event of a warning. While the system continues operation,
the AMSE controller outputs a warning signal, and the operation panel displays the code for the
warning.
When any warning is output, take measures to prevent the occurrence of serious failure.
Table 7.1b Warnings
7.1.3 Error messages
In the event of setting failure due to improper operation, an error code is displayed on the
operation panel.
Set the relevant parameter properly by referring to this manual.
Table 7.1c Error Messages
7.1.4 Status display
During operation, the operation status code is displayed on the operation panel.
Table 7.1d Status Display
Error Message
Name
Reference
HOLD
Operation Panel Lock
Er 1
Parameter Write Error - 1
Er 2
Parameter Write Error - 2
Er 3
Parameter Write Error - 3
Er 4
Parameter Write Error - 4
rE 1
Copy Operation Error - 1
rE 2
Copy Operation Error - 2
rE 3
Copy Operation Error - 3
rE 4
Copy Operation Error - 4
Err Error
Table 7.2e
Warning
Name
Reference
OL
Stall Prevention (Overcurrent)
Rb
Dynamic Brake Pre-alarm
Γ
H Electronic
Thermal
Pre-alarm
PS PU
Stop
CP Parameter
Copy
Fn Fan
Fault
oP
Hydraulic Control Board Warning
Table 7.2d
Note) Contact us when other warning codes are displayed.
Status
Name
Reference
E
П
G
Emergency Stop
Table 7.2f
