0 8
y t
2 . 2
LENKERMONTAGE – RENTHAL FATBAR CARBON 35
2.2 a //
Entferne die Kabelbinder mit dem Seitenschneider.
2.2 b //
Entferne die Schrauben am Vorbau mit dem Inbus-
schlüssel (4 mm), fette die Gewinde und lege sie zur Seite.
2.2 c //
Setzte die Schrauben in die Lenkerklemmung ein
und verschraube sie am Vorbau (Inbus 4 mm). Achte auf
die korrekte Ausrichtung der Lenkerklemmungen.
2.2 d //
Befestige zuerst die unteren Schrauben.
2.2 e //
Schraube die Klemmschellen mit dem angegebenen
Anzugsmoment komplett fest, bevor Du den Lenker mit
den oberen Schrauben klemmst. Achte darauf, dass kein
Spalt mehr vorhanden ist (zero gap).
2.2 f //
Achte auf einen gleichmäßigen Klemmspalt bei
den oberen Schrauben und auf den genauen, mittigen
Einbau des Lenkers. Die Einstelllinien helfen dir dabei.
Das Drehmoment der Schrauben sollte genau den Her-
stellerrichtlinien des Vorbaus und/oder Lenkers folgen.
C
d
e
a
b
F
Содержание RTFM JEFFSY
