y t
2 7
I
I I I II
II
II
I
I
EN
2.1 a //
Remove the handlebar clamp on the stem by
removing all screws (Allen key 4 mm ).
2.1 b //
Install the handlebar.
2.1 c //
Mount the handlebar to the stem (Allen wrench
4 mm). Tighten the screws in an X pattern. Do it step by
step with just one turn per screw at a time.This is the
only way to achieve an even clamping of the handlebar
in the stem.
2.1 d //
The torque of the screws should fit the handlebar
and /or stem manufacturer´s guidelines. Make sure the
clamp gap is even and the handlebar is centered and
inserted correctly. The adjustment lines will help you
with this.
2 . 1
HANDLEBAR ASSEMBLY – RACEFACE TURBINE
P l e a s e f o l l o w t h e t o r q u e
s p e c i f i c at i o n s o f t h e
m a n u fa c t u r e r s :
RaceFace Turbine //
5 Nm
a
b
c
d
Содержание RTFM JEFFSY
