![background image](http://html1.mh-extra.com/html/yokota/yz-th600/yz-th600_instruction-manual_3717953018.webp)
76-QD0460EN-01Y00-00
18
・
When pressing the push button for a long time for pairing, slowly remove the TF
pin from the push button right after the white LED goes off and the long beep starts.
Keep pressing can not enable the pairing.
・
Do not remove the battery pack from the tool, during the pairing.
⑤
When the pairing is successfully done, the light switch for pairing of receiver goes off and on the
tool side, the blue LED lights for 0.5 second together with buzzer beep sound.
When the pairing is failed, on the tool side the p urple LED lights for 0.5 second together with
intermittent buzzer beep sound. Do the pairing procedure once again from the beginning.
Condition
Buzzer sound pattern
LED lighting pattern
When pairing is
successful
The buzzer beeps
.
Blue lighting for 0.5 sec.
When pairing is failed
The buzzer beeps intermittently.
Purple lighting for 0.5 sec.
⑥
After the pairing is successfully done, put off the power switch of the receiver once without fail and
put it on again. By doing so, the communication can be possible with the tool paired.
Even if the pairing is successfully done, the communication with the tool can not be possible,
unless the power switch of the receiver is turned OFF/ON.
⑦
Others
・
Even if the battery pack is removed and installed again after the completion of pairing, the pairing
status is maintained. Likewise, even if the power switch of the receiver is turned OFF/ON, the pairing
status is maintained.
・
To release the pairing of the tool, do the pairing procedure at the status when the receiver is not in
the pairing mode. After it turns out to be the failure of the pairing (purple LED lighting), the pairing
will be released.