![background image](http://html1.mh-extra.com/html/yokota/yz-th600/yz-th600_instruction-manual_3717953009.webp)
76-QD0460EN-01Y00-00
9
■
2
.
Glossary
(1)
Value
A value at which the tool will shutoff once it reaches during rundown
(2) Tightening Value
The result value of a rundown
(3) Tightening Pulse No.
Number of pulses after reaching the display start value until shut-off.
(4) Display Start Value
Threshold value to judge OK or NG. At less than this value, no judgement is made.
(5) Switch Value
A value of switching point of motor speed from MID to HIGH rpm.
(6) Cut Value
The value at which the tool will automatically shut off during rundown
(7) Max Value
Maximum value to judge OK or NG
。
(8) LOW Speed:
Free speed when the throttle lever of the tool is pulled slightly to the first step (at right/left rotation)
(9) MID. Speed
Free speed when the throttle lever of the tool is pulled to full. (only at right rotation)
※
In case of reverse rotation, this setting is not valid. (Valid for low and high speed only).
(10) HIGH Speed:
Free speed after the Middle to High switch value is achieved. (at right rotation)
Free speed when the throttle lever of the tool is pulled to full. (at left rotation)
(11) MIN Pulse
Minimum pulse number for tightening to judge OK or NG.
(12) MAX Pulse
Maximum pulse number for tightening to judge OK or NG.
(13) Average Number
The arithmetic average from the preset number of pulses.
(14) Slow Error Pulses
The number of pulses in excess of the preset number (70 fixed) of pulses, including those less than
display start value, to judge.
(15) Value Judgement before average
Value over judgement as a base of the value before the arithmetic average