YOKOGAWA FVX110, Руководство пользователя

Страница: 70 / 168

<9. In-Process Operation>
9-3
IM 01S01C01-01EN
Table 9.2 Field Diagnostic Alert
Indication of FD_*_ACTIVE Indication of FD_RECOMMEN_ACT Solution
Electronics failure Repair electronics Replace electrical parts e.g. amplifier.
Or contact sales office or service
center.
Sensor/Actuator failure Repair Sensor/Actuator Replace mechanics e.g. sensor or
actuator. Or contact sales office or
service center.
Potential failure Investigate failure Perform reconfiguration, cleaning,
wiring/connector or electrical board
check.
If alarm still persists, contact sales
office or service center.
Backup function in operation Repair primary side Repair primary sensor before backup
sensor fails.
Firmware update error Retry updating firmware Retry firmware update. Check cause of
the failure if alarm persists.
Communication configuration error Configure communication correctly Correct configuration of
communication.
Non-operating-state Wait for a while Wait for a while. Check cause of the
failure if alarm persists.
Calibration warning Check calibration Investigate cause of failure and
recalibrate device.
Device configuration error Configure device correctly Correct configuration relating to sensor
or actuator.
Function restricted Confirm the state Check if this is right state.
Simulation mode Confirm the state Check if this is right state.
Manual mode Confirm the state Check if this is right state.
Function Block notice Check Function Block status Check conditions of function
blocks. In order to avoid alarm from
unused function blocks, configure
RESOURCE2.FD_EXTENDC_MAP_n
(n: 1 to 3) parameter.
Sensor/Actuator out of range Check specification Check specification of sensor and
actuator. Or process conditions may be
temporarily non-conforming.
Out of operating limit Check environment Check environment specification
of sensor and actuator. Or process
environment may be temporarily non-
conforming.
Temporal decrease of value quality Check process or peripherals Check process and peripherals
conditions.
Deterioration estimated by Time Based
Maintenance
Check deterioration Check if maintenance is required.
Deterioration estimated by Condition
Based Maintenance
Check deterioration Check if maintenance is required.
Optional function configuration error Check optional configuration Check configuration of optional
functions.
Alarm related information Confirm information Check the alarm related information.
Process alarm Check process Check process conditions.