Yenista Optics OSICS, Руководство пользователя

Страница: 156 / 252

Using the OSICS SWT APC Module
156 OSICS User Manual
BKR
TL
S-50
AT
N
DFB
EC
L
T100
SLD
SW
T
TLS-A
G
SW
T A
PC
MAI
N
12.4 Configuring the Full-Band Mode
The OSICS SWT APC optical switch module enables you to drive from 1 to 2 or to 1 to 4
(depending on your SWT APC model) OSICS T100 and OSICS ECL modules plugged in
the same OSICS Mainframe: you select a wavelength and an output power in the
OSICS SWT APC setup menu, and the module automatically selects the channel and
drives the OSICS T100 or ECL to provide the wanted values.
To use the OSICS SWT APC in Full-Band mode, the module must know where OSICS T100
and OSICS ECL modules are located in the Mainframe. For this, you can use one of the
following methods:
• Manual configuration : use this method if an OSICS T100 or ECL is running with
another application, or if an ECL has a software version prior to v. 2.21 (in this case the
wavelength range cannot be automatically defined).
• Automatic detection : use this method if the OSICS T100 and ECL modules installed
in the Mainframe are not running for other applications.
12.4.1 Automatically Detecting the T100 and ECL Modules Connected
to the SWT APC
Subject The OSICS T100 and ECL modules already installed in the Mainframe (not being used by
other applications) can be automatically detected by the OSICS SWT APC module.
The automatic detection does not work for ECL modules with a software version prior to
v. 2.21.
The auto configuration takes approximately 20 seconds. During this operation, the
optical outputs of the connected OSICS T100 or OSICS ECL are sequentially turned off
and on.
Before Starting • Connect the wanted OSICS T100 and ECL to the input ports of the OSICS SWT APC
Ch 1 to Ch n .
• Set the SWT APC to Full-Band mode (see section Selecting the Operating Mode,
p. 154 ) and configure the connected modules (section Configuring the Full-Band
Mode, p. 156 ).
Procedure 1. Access the SWT APC Unit Setup menu (see section Accessing an OSICS Module Setup
Menu, p. 33 ).
2. Expand the ECL vs Channel menu enter the Auto menu.
The ECL vs Channel menu appears, prompting you to start the detection.
3. Press the knob to start the detection.
The SWT APC sequentially disables and enables the optical output of the connected
OSICS T100 and ECL modules.
If two OSICS T100 or ECL modules have common wavelengths, the SWT APC selects
the first module in the mainframe to achieve the range.
Once the automatic detection is complete the automatically detected values are
displayed.