Yenista Optics OSICS, Руководство пользователя

Страница: 26 / 252

Installing and Connecting the OSICS Multifunction Platform
26 OSICS User Manual
2.4 Connecting Optical Devices to OSICS Modules
Subject You can connect external optical components and instruments to the OSICS modules.
Before Starting Make sure you have the appropriate fiber type corresponding to the modules you want
to connect. For details on the appropriate optical fiber type, see the Technical
Specifications section corresponding to the modules you want to connect in the
appropriate module section of this manual)
Procedure 1. Disable the laser output before connecting or disconnecting a fiber optic cable on
the module (see section Enabling/Disabling the Light Source of All Modules, p. 37 ).
2. Make sure fiber-optic connectors are clean.
3. On the front panel, lift the protective cap and connect the optical component(s) to
the OSICS module via the FC/APC fiber-optic connector.
4. In case of frequent connect/disconnect, use an intermediate jumper to prevent
premature failure of the OSICS module internal connector.
• Keeping fiber-optic connectors clean at all times is essential to
achieve optimum system performance (see section Cleaning Optical
Connectors, p. 243 ).
• The standard output connector is a FC/APC connector. Never connect
another type of connector to the optical output.
CAUTION
The use of optical instruments with this product increases eye hazard.
Do not look directly into the fiber end of an optical cable connected to
any optical output while the device is in use. This may cause permanent
eye damage.
WARNING
On OSICS SWT, do not connect several laser sources at the same time
on the Com and Chn channels, or you may severely damage your
optical equipment.
CAUTION