Yealink T5 Series, Руководство администратора

Страница: 37 / 472

Phone Network
31
Phone UI Settings->Advanced Settings (default password: admin) ->Network->LLDP->Packet Interval
[1]
If you change this parameter, the phone will reboot to make the change take effect.
CDP Configuration
CDP (Cisco Discovery Protocol) allows the phones to receive and/or transmit device-related information from/to dir-
ectly connected devices on the network that are also using the protocol, and store the information about other
devices.
If the CDP feature is enabled on the phones, the phones will periodically advertise their own information to the directly
connected CDP-enabled switch. The phones can also receive CDP packets from the connected switch. If the VLAN con-
figurations on the phones are different from the ones sent by the switch, the phones will perform an update and
reboot. This allows you to connect the phones into any switch, obtain their VLAN IDs, and then start communications
with the call control.
The following table lists the parameters you can use to configure CDP.
Parameter
static.network.cdp.enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the CDP feature.
Permitted
Values
0 -Disabled
1 -Enabled, the phone attempts to determine its VLAN ID through CDP.
Default 1
Web UI Network->Advanced->CDP->Active
Phone UI Settings->Advanced Settings (default password: admin) ->Network->CDP->CDP Status
Parameter
static.network.cdp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) that how often the phone sends the CDP request.
Note : It works only if “static.network.cdp.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 3600
Default 60
Web UI Network->Advanced->CDP->Packet Interval (1~3600s)
Phone UI Settings->Advanced Settings (default password: admin) ->Network->CDP->Packet Interval
[1]
If you change this parameter, the phone will reboot to make the change take effect.
Manual VLAN Configuration
VLAN is disabled on the phones by default. You can configure VLAN for the Internet port and PC port manually. Before
configuring VLAN on the IP phone, you need to obtain the VLAN ID from your network administrator.
The following table lists the parameters you can use to configure VLAN manually.
Parameter
static.network.vlan.internet_port_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the VLAN for the Internet port.
Permitted
Values
0 -Disabled
1 -Enabled