n
Execution
–
Select how often the interrupts are to be triggered.
–
Intervals ranging from every minute to yearly are available. The intervals apply to
the settings made for
start date
and
time
.
n
Start date/time
–
Enter date and time of the first execution of the time-of-day interrupt.
n
Process image partition
–
This parameter is not supported.
n
Priority
–
Here the priorities may be specified according to which the corresponding cyclic
interrupt is processed.
n
Execution
–
Enter the time intervals in ms, in which the watchdog interrupt OBs should be pro-
cessed.
–
The start time for the clock is when the operating mode switch is moved from
STOP to RUN.
n
Phase offset
–
Enter the delay time in ms for current execution for the watch dog interrupt. This
should be performed if several watchdog interrupts are enabled.
–
Phase offset allows to distribute processing time for watchdog interrupts across
the cycle.
n
Process image partition
–
This parameter is not supported.
n
Report cause of STOP
–
Activate this parameter, if the CPU should report the cause of STOP to PG
respectively OP on transition to STOP.
n
Number of messages in the diagnostics buffer
–
This parameter is ignored. The CPU always has a diagnostics buffer (circular
buffer) for 100 diagnostics messages.
n
Synchronization type
–
Here you specify whether clock should synchronize other clocks or not.
–
as slave: The clock is synchronized by another clock.
–
as master: The clock synchronizes other clocks as master.
–
none: There is no synchronization
n
Time interval
–
Time intervals within which the synchronization is to be carried out.
n
Correction factor
–
Lose or gain in the clock time may be compensated within a 24 hour period by
means of the correction factor in ms.
–
If the clock is 1s slow after 24 hours, you have to specify a correction factor of
"+1000" ms.
Cyclic interrupts
Diagnostics/Clock
VIPA System MICRO
Deployment CPU M13-CCF0000
Setting standard CPU parameters > Parameter CPU
HB400 | CPU | M13-CCF0000 | en | 18-50
79
