8.5 Estimating the Moment of Inertia
8.5.4 Operating Procedure
8-21
8
T
uning
10.
Click the
Forward
Button.
The shaft will rotate in the forward direction and the measurement will start. After the measurement
and data transfer have been completed, the
Reverse
Button will be displayed in color.
11.
Click the
Reverse
Button.
The shaft will rotate in the reverse direction and the measurement will start. After the measurement
and data transfer have been completed, the
Forward
Button will be displayed in color.
12.
Repeat steps 9 to 11 until the
Next
Button is enabled.
Measurements are performed from 2 to 7 times and then verified. The number of measurements is
displayed in upper left corner of the dialog box. A progress bar at the bottom of the dialog box will
show the progress of the transfer each time.
13.
When the measurements have been completed, click the
Servo On
Button to turn OFF
the servo.
14.
Click the
Next
Button.
The Write Results Dialog Box will be displayed.
If you click the
Next
Button before you turn OFF the servo, the following Dialog Box will
be displayed. Click the
OK
Button to turn OFF the servo.
Information
