YASKAWA LA500, Техническое руководство, Страница: 348 / 376

12.9 o: Keypad-Related Settings
348 YASKAWA SIEPYEULA5001C LA500 Technical Manual
■
o1-01: User Monitor Selection
No.
(Hex.)
Name Description
Default
(Range)
o1-01
(0500)
RUN
User Monitor Selection
Sets the U monitor for the Drive Mode. This parameter is only available with an LED keypad.
106
(104 - 830)
When the drive is in Drive Mode, push on the keypad to cycle through this data: frequency reference →
rotational direction → output frequency → output current → o1-01 selection.
Set the x-xx part of Ux-xx that is shown in the fifth position in Drive Mode. For example, to show U1-05 [Motor
Speed] , set o1-01 = 105 .
Note:
The monitors that you can select are different for different control methods.
■
o1-02: Monitor Selection at Power-up
No.
(Hex.)
Name Description
Default
(Range)
o1-02
(0501)
RUN
Expert
Monitor Selection at Power-
up
Sets the monitor item that the keypad screen shows after you energize the drive. Refer to “ U:
Monitors
”
for information about the monitor items that the keypad screen can show. This
parameter is only available with an LED keypad.
1
(1 - 5)
1 : Frequency Reference (U1-01)
2 : Direction
3 : Output Frequency (U1-02)
4 : Output Current (U1-03)
5 : User Monitor (o1-01)
Shows the monitor item selected in o1-01 [User Monitor Selection] .
■
o1-03: Keypad Display Unit Selection
No.
(Hex.)
Name Description
Default
(Range)
o1-03
(0502)
Keypad Display Unit
Selection
Sets the display units for the frequency reference and output frequency.
0
(0 - 3)
Note:
• Select the setting unit of these parameters:
–
d1-01 to d1-08 [Reference 1 to 8]
– U1-01 [Frequency Reference]
–
U1-02 [Output Frequency]
–
U1-05 [Motor Speed]
– U1-16 [SFS Output Frequency]
–
U4-14 [PeakHold Output Freq]
•
For monitor 2, the setting value is always 0 [Hz Unit] .
0 : 0.01 Hz units
1 : 0.01% units
The maximum output frequency is 100%.
2 : Revolutions Per Minute (RPM)
The drive uses the maximum output frequency and number of motor poles calculate this value automatically.
Note:
When you set o1-03 = 2 [r/min] , make sure that you set the number of motor poles in E2-04 [Motor Pole Count] .
3 : User Units
Uses o1-10 and o1-11 to set the unit of measure. The value of parameter o1-10 is the value when you remove the
decimal point from the maximum output frequency. Parameter o1-11 is to the number of digits after the decimal
point in the maximum output frequency.
To display a maximum output frequency of 100.00, set parameters to these values:
V/f OLV
V/f OLV
V/f OLV