8 - 58
CHAS
STEERING SYSTEM
h. Attach the assembled ball joint remover,
new ball joint
B
and installer attachment
8
to the steering knuckle
C
.
TIP:
Do not tap or damage the top of the ball joint.
i. Hold the body
3
in place while turning in
the long bolt
4
to install the new ball joint
B
into the steering knuckle
C
.
j. Remove the ball joint remover.
k. Apply lithium-soap base grease to the new
ball joint
B
.
l. Install a new rubber boot and new circlip.
TIP:
Always use a new ball joint set.
m. Install a steering knuckle oil seal.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
3. Check:
• front wheel bearings
Bearings allow play in the wheel hubs or the
wheel turns roughly
→
Replace.
• oil seals
Damage
→
Replace.
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Clean the outside of the steering knuckle.
b. Remove the oil seals
1
.
c. Drive out the bearings
2
.
WARNING
Eye protection is recommended when
using striking tools.
d. Remove the spacer
3
.
e. Apply lithium base grease to the bearings
and oil seals.
f. Install the spacer to the steering knuckle.
g. Install the new bearings.
TIP:
Install the outside bearing first.
NOTICE
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
2
1
1
3
Содержание YXR70FX
