PREPARATIONS
➤
f
Initial settings
En
35
❑
AUTO SETUP via the setup menu
“Beam optimize only” or “Sound optimize only” can be measured
separately in the setup menu.
1
Place the IntelliBeam microphone at your normal
listening position, and press the SETUP (
) key.
See “Installing the IntelliBeam microphone” (p. 32) for
instructions on positioning the IntelliBeam microphone.
2
Press the
S
/
T
key to select “Beam” and then press
the ENTER key.
3
Press the
S
/
T
key to select “IntelliBeam” and then
press the ENTER key.
4
Press the
S
/
T
key to select one of the items below
and then press the ENTER key.
Settings
5
Connect the IntelliBeam microphone to this unit
after “AUTO SETUP (PREPARATION & CHECK)”
screen is displayed.
For details on connecting IntelliBeam microphone, refer to
“Using AUTO SETUP (IntelliBeam)” (p. 33).
6
Follow steps 4, 5, and 6 under “Using AUTO SETUP
(IntelliBeam)” to configure settings, and then
remove the microphone.
• When the AUTO SETUP procedure is performed from the setup menu, the menu
selection screen of the setup menu appears. Press the SETUP (
) key to exit
the setup menu.
Beam+Sound optimize
Select this optimization feature if you make
settings for the first time. This menu takes
about 3 minutes.
Beam optimize only
Use to optimize the beam angle so that the
parameter best matches your listening
environment. This menu takes about 1
minute.
Sound optimize only
Use to optimize the beam delay, volume,
and quality so that the parameters best
match your listening environment. This
menu takes about 2 minutes.
You must optimize the beam angle with
“Beam optimize only” before starting
“Sound optimize only”. Select this
optimization feature in the following cases:
• If you have opened or closed the curtains
in your listening room before using this
unit
• If you have manually set the beam angle
with “Beam optimize only”.
1 2 3 4 5 6
/
/
ENTER
S
ETUP ( )
