Yamaha GRIZZLY 700 FI YFM7FGPW, Руководство по обслуживанию

Страница: 338 / 485

7 - 26
DRIV
REAR CONSTANT VELOCITY JOINTS AND FINAL
DRIVE GEAR
3) If “–05” is stamped on the final drive pinion
gear bearing housing,
c
= 67.8 – 0.05
= 67.75
NOTE:
After replacing any part in the final drive pinion
gear assembly, the overall length of the
assembly will change. Therefore, be sure to
measure distance
c
to select the correct final
drive pinion gear shim thickness.
4) If “–01” is stamped on the final gear case,
d
= 100 – 0.01
= 99.99
5) Therefore, “A” is 0.58
“A” = 55 + (67.75 – 22.18) – 99.99
= 0.58
6) Round off the hundredth digit and select the
appropriate shim(s).
In the example above, the calculated num-
ber is 0.58. The chart instructs you to round
off 8 to 10 at the hundredth place. Thus, the
shim thickness is 0.60 mm (0.024 in).
Shims are supplied in the following thick-
nesses.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Hundredths Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Final drive pinion gear shim
Thickness (mm)
0.25 0.30 0.35
0.40 0.45 0.50
c
c
d