Operation
63
after 5 seconds of cranking, return the
main switch to “
” (on), wait 10 sec-
onds, then crank the engine again.
[ECM00192]
TIP:
The sub station can start and stop the engine.
However, it cannot operate the digital elec-
tronic control.
EMU35762
Procedure for dual station models (sub
station)
WARNING
EWM01840
●
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-off
cord to a secure place on your clothing,
or your arm or leg while operating. Do
not attach the cord to clothing that could
tear loose. Do not route the cord where
it could become entangled, preventing it
from functioning.
●
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1.
Turn the main switch of the main station
to “
” (on) to make sure that the digital
electronic control-active indicator lights.
The engine can not be started when the
digital electronic control-alert indicator
lights.
2.
Place the control lever in “ ” (neutral).
3.
Push the station selector switch of the
sub station. Station change is only possi-
ble when all control levers have been set
to “ ” (neutral). Make sure that the digital
electronic control-active indicator of the
sub station lights.
4.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
ZMU05976
ZMU05995
ZMU05996
U6BR11E0.book Page 63 Friday, June 13, 2008 3:43 PM
©
2019 Yamaha Motor Corporation, U.S.A.
