59
Scanning Function
Using the Scanning Function
Selecting a Reception Method When Scanning Stops
When scanning stops, you can select one of the following three reception methods:
(1) The signal is received for the specified period of time, and then scanning resumes.
You can specify this period of time in steps of 0.5 second within the range from 2 to
10 seconds.
(2) The signal is received until it fades out. Two seconds after the signal fades out,
scanning resumes. [BUSY] appears on the LCD.
(3) Scanning stops and the current frequency is received. [HOLD] appears on the LCD.
1
Press and hold
M
for over 1 second.
2
Turn
O
to select [5 SCAN].
3
Press
H
.
4
Turn
O
to select [4 SCAN RESUME].
5
Press
H
.
6
Press
H
again.
7
Turn
O
to specify the reception method.
Select a reception method from [2 SEC TO 10 SEC (0.5
SEC STEP)], [BUSY], and [HOLD].
8
Press
p
to save the specified reception method and exit
from the Set mode.
Tips
• The reception method selected here is also applied to [VFO Scanning], [Programmable Memory
Channel Scanning] and [Memory Channel Scanning].
• The scanning restart time after BUSY (duration of signal reception) can be changed by selecting the
Set mode option [5 SCAN RESTART] [3 SCAN RE-START].
Memory Channel Scanning
Frequencies registered to the memory channels can be scanned in the order of memory
channel number.
1
Switch to the Memory mode and recall a memory channel.
2
Press
F
and then
2
.
Scanning (SCAN) is performed toward higher memory
channel numbers.
When a signal is received, the decimal point blinks.
䎗䎃 䎶䎦䎤䎱䎃
䎶䎦䎤䎱䎃䎃䎵䎨䎶䎸䎰䎨
䎵䎨䎶䎸䎰䎨
䎃䎃䎃 䎶 䎦䎤䎱䎃
䎦䎤䎱䎃䎃 䎝 䎃䎘 䎑 䎓 䏖 䏈 䏆
䎃 䎃䎃䎧䎺䎃䎃䎃䎃
䎧䎺䎃䎃䎃䎃䎃 䎝䎃䎃䎫䎲䎯䎧䎃䎃
䎝䎃䎃䎫䎲䎯䎧䎃䎃䎃 䎃
䎃
䋱䋶䋰
When a signal is received,
the decimal point blinks.
FT1DR̲DE̲Eng.indb 59
FT1DR̲DE̲Eng.indb 59
13/06/28 15:16
13/06/28 15:16
