Xtreme XR3034, Руководство по эксплуатации и безопасности

Страница: 56 / 76

Operation Manual 56
Operation
Warning
To prevent death or serious injury, the
operator must be seated with seat belt
fastened, the travel select lever set to
NEUTRAL, the Parking Brake ON (engaged),
and the area free of people and obstructions
BEFORE starting the forklift.
1. Start the forklift. Refer to the Starting Forklift section in
this manual.
2. Select Transmission Range.
3. Apply service brake.
4. Release parking brake.
5. Rotate gear select switch to the desired gear.
6. Move the travel select lever to FORWARD or REVERSE for
the appropriate direction of travel.
7. Release the service brake pedal.
8. Slowly press the accelerator pedal to start travel.
Shifting Gears
Warning
Allow the engine speed to slow down before
shifting to the next lower gear. Improper
use of the gear select lever could cause
transmission damage or forklift tip over/roll
over and could result in death or serious
injury.
The transmission has three (3) gears both in
HI
and in
LO
that
can be used for traveling forward or reverse.
To shift gears, rotate the gear select lever to the next gear
while the forklift is traveling.
•
Use first low gear (1 LO ) for the highest torque and pulling
power.
• Use higher gears in HI for higher ground speed.
• Never travel in higher gears when carrying a load.
• Allow the engine speed to slow down before shifting to
a lower gear.
Warning
Use proper safety procedures and avoid
hazardous situations while operating the
forklift to prevent death, serious injury, or
property damage.
• Check the work site for any hazards before operating
the forklift.
• Check the work surface for loose soil conditions and
overhead power lines.
Starting Travel
Warning Indicators
Warning
A fault condition may trigger a popup dialog
box on the display describing the nature of
the fault during operation. Corresponding
red or amber warning lights will illuminate to
indicate the severity of the fault. If a fault
condition is present, stop the forklift, follow proper shut
down procedures, tag the forklift with “Do Not Operate”
tags, and have a qualified mechanic service or repair the
forklift BEFORE placing it into service again. Ignoring
warning indicators or fault codes can cause improper
performance, which could result in death, serious injury, or
property damage.
Fault condition dialog boxes will pop up and warning lights
on the display will illuminate during critical circumstances.
Some of these conditions demand immediate attention and
forklift servicing. The forklift should be shut down as soon as
practical to prevent serious mechanical failure.
Shifting Transmission Range
Stop the reachfork and set the parking brake to ON
(engaged).
Press the transmission range toggle switch down to shift to
LO range or up to shift to HI range. Note the toggle switch
always returns to the centered position. The lights indicate
the range the transmission is in.
The transmission always shifts to HI range upon starting the
engine.