Xo FLEX, Руководство по установке

Страница: 34 / 59

XO FLEX – Installation instructions Installation
34
Always remember to fit the cover plug into the hole of the outer cylinder. See Figure
43.
FITTING THE CABLES TO THE OPERATING LIGHT
Secure the cables with cable ties and connect plugs to J11, LAMP.SIG. (on back
plane) and on J5, Stand control PCB. See Figure 44.
Figure 44 – (1) CA-013 (J5, Stand control PCB), (2) CA-012 (J11, Backplane PCB)
5.7 FITTING OF XO HD DISPLAY
If the unit has been supplied with an XO HD Display, the outer Ø100 mm cylinder is divided into
two parts (an upper short and a lower long one) and the light arm post has separate friction
adjustments for the display arm and for the light arm.
1.
Fit the light arm post as described in section 5.6.2.
2. When the light post has been tightened securely, the lower Ø 100 mm outer cylinder shall be
fitted – see Figure 45.
3. Fit the display arm – see Figure 46.
4. Fit the O-ring and the adjustable plastic ring on the light post over the display arm, as shown in
Figure 46.
5. Route the cables from the display through the groove in the plastic ring and through the hole in
the light post. See Figure 47.
6. Push the cables through the post until they appear in the electronics side of the unit stand.