XITRON 2000I, Руководство пользователя

Страница: 46 / 96

46
2000I & 2000M User Guide, Rev B
Front Panel Memory
The front panel memory steps may be either edited or recalled by initially
pressing the MNU key.
Editing Memory Steps
1. Press the MNU key twice. The display now shows the choice:
< Edit Memory >
2. Press any of the ENTER keys to select this choice. The display now
shows the prompt for the memory step number to be edited, for example:
< Press Memory 5 >
3. You may press the CLR or MNU keys at this time to terminate the
procedure. Press the numeric key corresponding to the memory to be
edited. The display now shows the present status of the selected memory
step, either:
< Inactive >
or
< Active >
4. The displayed status of the memory step may be toggled by pressing any
of the arrow keys or the MNU key. When the desired status is shown,
press any of the ENTER
keys to select. If the Inactive state was selected,
the display will return to the prompt (step 2 above):
< Press Memory 5 >
5. The display then shows the presently stored output level, multiplier and
unit. The memory step number being edited is shown in the right-hand
end of the display.
6. You may now enter the desired output level into the memory step. The
multiplier used during this entry (if any) will be used for formatting the
display following recall of the step. The entry is terminated when a valid
Units/Enter key
( V, A, ºC or ºF) is pressed. The display now shows the
present selection as to whether the instrument will be in the “Operate” or
“Standby” state following recall of the step. The memory step being
edited is shown in the left-hand end of the display.