XITRON 2000I, Руководство пользователя

Страница: 38 / 96

38
2000I & 2000M User Guide, Rev B
7. The display then prompts you to select the required user entry units. You
may sequentially select (for each character position) the desired character
by using the
, 8 5
and
2 6
keys. Note that both upper- and lower-case
characters are available and up to three characters may be specified. To
terminate the selection of each character press the 6
4
key and select the
next character to be entered, or press any of the Units/Enter keys (V, A,
ºC or ºF
)
to terminate the entry.
Note:
The list of available characters is as follows, in the order selected:
•
The $, %, and / characters;
•
The upper-case alphabet (i.e., A through Z);
•
The lower-case alphabet (i.e., a through z);
•
The º and ì characters.
8. The display then prompts you to enter Output B (i.e., the actual output
level for point B), and displays the presently stored data. Press any units
key (if this data is to be retained) or enter the desired data followed by
any units key. Note that the units for this data are automatically those
previously selected for the Output A data.
9. The display then prompts you to enter User Data B and displays the
presently stored data. Press any units key (if this data is to be retained) or
enter the desired data and then press any units key. Note that the units for
this data are automatically those previously selected for the User Data A
data.
10. Following entry of the above data, the instrument will then initiate the
“Calculated Output” mode of operation.
Operating in the Calculated Output Mode
Operation of the instrument while in the “Calculated Output” mode of
operation is the same as that while in the normal mode of operation, with the
following exceptions:
1. Numeric entries of the required output level are in the user units set
during the set-up of this mode of operation, thus the unit key used to
terminate the entry is discarded.