XITRON 2000I, Руководство пользователя

Страница: 40 / 96

40
2000I & 2000M User Guide, Rev B
The instrument will then begin measuring the applied voltage, converting it
into the computed temperature for the selected thermocouple type.
•
To display the measured voltage:
Press the V key.
•
To show the computed temperature in the respective units.
Press the ºC or ºF key.
•
To reformat the display using the desired multiplier:
Press the ì or m keys while the display is showing the measured
voltage.
Deselecting Measurement Mode
While the instrument is in the Measure mode of operation, the “Output” mode
may be selected in the following manner:
1. Press the MNU key. If the instrument is presently in the “Operate” state,
then disconnect the voltage or thermocouple previously being measured.
2. Repetitively press any of the arrow keys until the “Output” prompt is
displayed.
3. Press any of the Units/Enter keys to select the “Output” mode.
Rear Panel Operation
All the connections available on the 2000 instruments rear panel are depend-
ent on which options are
fitted . Refer back to the Rear Panel Connections
and Controls .
Note:
In the 2000M instrument, the thermocouple simulation output, or
thermocouple measurement input, should be taken from the connector
mounted on the rear panel.
Using Thermocouple Simulation
The type of thermocouple to be simulated or measured may be altered,
whether active or passive cold junction compensation (CJC) is used, and
whether the cold or reference temperature is used. Note that this data is