XITRON 2000I, Руководство пользователя

Страница: 42 / 96

42
2000I & 2000M User Guide, Rev B
•
To achieve Thermocouple Simulation:
1. Press the MNU key, the display will prompt you to select either the
“Standby” or “Operate” state.
2. Press any arrow key repeatedly until either one of the following appears:
< Use Active CJC >
—Or—
< Use Passive CJ >
3. If the instrument is (presently) set to use active CJC the display will
read: “Use Passive CJ”. This feature allows you to select the opposite
mode.
4. If the displayed selection is required, then press any of the Units/Enter
keys (V, A, ºC or ºF
)
, otherwise press the CLR key to abort the
selection.
•
To achieve Thermocouple Measurement Set-Up:
1. Press the MNU key and the display will prompt you to select either the
“Standby” or “Operate”
state.
3. Neither “Standby” nor “Operate” are desired actions, therefore continue
to press any of the arrow
keys repeatedly until the “Thermocouple” set
up action is displayed.
< Thermocouple >
4. Press any of the Units/Enter keys (V, A, ºC or ºF
)
to select
“Thermocouple”.
5. The display then shows the default thermocouple type to be simulated
similarly to the display shown below. Here a type “R” thermocouple is
to be simulated.
< Type-BEJNRST >
6. Then select the required default thermocouple type to be simulated by
repeatedly pressing the 4
3
(left arrow) or 6
4
(right arrow) keys until
the required thermocouple type is underlined. The selection is then made
by pressing any of the Units/Enter (V, A, ºC or ºF) keys.