Xinje DS3 series servo, Руководство пользователя

Страница: 73 / 152

71
5-3-8. Command pulse prohibition (/INHIBIT)
To stop the commnad pulse input in position control mode. When /INHIBIT signal is ON, the
command pulse stop counting.
Input signal setting:
5-3-9. Positoin pulse difference
When the pulse difference over the limit value in position control mode, servo will alarm. This limit
value is pulse difference limit.
P0-23
Pulse difference limit
Unit Default value Range Suitable
mode Change Effective
256
commands
50000 0~65535 6 Any At once
When the P0-23=0, it will now detect the pulse difference value.
5-4
．
Speed control (analog voltage command) (Only for
DS3-PQA)
Basic parameters
Parameter Name Reference
P0-01 Select the control mode 5-4-1
P3-00 V-REF distribution 5-4-2
P3-01 Rated speed of the corresponding analog voltage
P3-02 Analog voltage speed filter
P3-03 Speed command input dead zone voltage
P3-14 Forward direction max speed command limit
P3-15 Reverse direction max speed command limit
P5-20 Servo ON signal /S-ON 5-2-1
Other parameters
Key words Parameter Name Reference
Zero drift F1-03 Analog voltage speed command offset 5-4-3
Parameter Signal Default Suitable
mode
Modify Effective Modify
P5-32 /INHIBIT n.0000 6 Any At once Range: 0000-0015. When it
set to 0001, it means input
from SO1.
Note: /INHIBIT can be input from input terminal by setting P5-32. Please refer to chapter 5-12-1
（
alarm E-100
）
Normal
control
（
alarm E-100
）
Pulse
difference 0
P0-23