Xerox B205, Руководство по обслуживанию

Страница: 65 / 206

July 2019
3-10 Xerox® B205/B215 Multifunction Printer Service Manual
IQ10, IQ11
Initial Release Image Quality
IQ10 Side 2 Staining
Side 2 of a simplex or duplex print is stained, Figure 1 .
Procedure
Switch Off the Power.
Check the Transfer Roller,
PL 4.1 Item 10 , for:
• Wear or damage.
• The left and right tension springs for damage.
• Be sure all parts are installed correctly.
The Transfer Roller is OK.
Y
N
Install a new Transfer Roller, PL 4.1 Item 10 .
If the fault persists, Install a new Fuser Module, PL 5.1 Item 26 .
Figure 1 Side 2 Staining
IQ11 Blank Page RAP
The entire image area is blank, Figure 1 .
Initial Actions
Replace any components at end of life, refer to GP 6 Machine Reports.
Procedure
• Switch Off the power.
• Check the space between the LSU and the Drum Cartridge, remove any debris or block-
age.
• Clean the terminals on the Toner Cartridge, Drum Cartridge, and the HVPS PWB.
• Switch on the power and make a test print.
The problem continues.
Y
N
Go to Call Closeout.
Install a new Drum Cartridge, refer to the Xerox® B215/B205 User Guide, Section 6 Mainte-
nance, General Care, for detailed instructions on how to Install a new Drum Cartridge.
The
problem continues.
Y
N
Go to Call Closeout.
Check the circuit between the Main PWB and the HVPS PWB, refer to BSD 1. Main/Electrical/
Power/Drive/LSU/Fuser/Network , The circuit is OK.
Y N
Replace any defective components:
• Main PWB to LVPS / HVPS PWB Wire Harness.
• Main PWB, PL 1.1 Item 4 .
• HVPS PWB, PL 4.1 Item 10 .
Go to Call Closeout.