Xerox 2101, Руководство пользователя, Страница: 142 / 444

112
Making Copies
Added Fe
atures
Basic Features
Image Quality
Stored Job Templates
Output Format
5.10
Erasing Edges
This feature allows you to erase shadows or marks that might be created at the edges or the center of the
copies when copying bound documents. Options available for this feature are:
Top and Bottom Edges
Erases shadows at the top and bottom edges of the copies.The edges are erased based on the orientation
of the document set. You can specify the width of the edge erase within 0-50 mm in 1 mm increments.
Left and Right Edges
Erases shadows at the left and right edges of the document.The edges are erased based on the orientation
of the document set. You can specify the width of the edge erase within 0-50 mm in 1 mm increments.
Top Edge
/
Bottom Edge
/
Left Edge
/
Right Edge
Erases shadows at the top, bottom, left, and right edges of the document independently. You can specify
each width within 0-50 mm in 1-mm increments.
Binding Erase
Erases shadows at the center of the copies when copying bound documents.You can specify the width of
the binding erase within 0-50 mm in 1 mm increments.
● Binding Erase cannot be used together with the Multiple Up or Repeat Image feature.
● When Binding Erase is selected with the Bound Originals feature, only half of the Binding Erase width will be erased.
●
This feature works based on the orientation of the document loaded. The edges will not be correctly erased if the document is
not loaded in the direction specified in Original Orientation. For details, refer to “5.14 Specifying Image Orientation”.
● If Multiple Up is selected together with Top and Bottom Edges or Left and Right Edges , the erase width applies to the
individual documents before they are copied onto one sheet.
●
The erase width applies to the document. Regardless of the erase width, there will be an image loss of approximately 3 mm off
the edges of the copies.
● When Reduce/Enlarge is selected, the erase width is adjusted according to the reduce/enlarge percentage.
● When 2-Sided is selected, the erase width applies to both sides of the document.
●
The factory settings for Top and Bottom Edges, Left and Right Edges, and Binding Erase are 2 mm, 2 mm, and 0 mm
respectively.
● You can change the factory setting for Top and Bottom Edges and Left and Right Edges in Tools Mode. For details, refer to “8.3
Setting Tools Mode”. You cannot change the factory setting for Binding Erase in Tools Mode.
Edge Erase
Top and Bottom Edges Left and Right Edges
Binding Erase
Top and Bottom Edge/Left and
Right Edge/Binding Erase
area erased
Areas that can be erased