Commissioning
975-0400-01-01
2–23
Commissioning
During commissioning, the XW SCC prompts you to enter important system
information such as the nominal battery voltage, battery type, and battery bank
capacity. Ensure you have this system information prior to commissioning.
In systems where an XW System Control Panel (SCP) is present, the SCP is
intended to be the configuration interface, so the prompt screens are suppressed.
See “Commissioning Units Using a System Control Panel” on page 2–27. If you
prefer to configure using the prompt screens, disconnect the Xanbus cable from
the XW SCC before powering up for the first time.
Configuration Screens
When power is first applied to the XW SCC, several configuration screens prompt
you to enter the following information:
•
A “DC out” (battery) connection, which enables the XW SCC to read and
share the same battery information with other Xanbus-enabled devices that
charge or invert from the same battery bank.
•
Battery type: Flooded (default), Gel, AGM, Custom.
If you select Custom, the settings for battery type match the default settings
for Flooded batteries until you reconfigure the settings on the Custom Battery
menu. See “Setting a Custom Battery Type” on page 3–8.
•
Nominal battery voltage of the battery bank connected to the XW SCC.
The XW SCC automatically detects battery voltages of 12 V, 24 V and 48 V.
If your nominal system voltage is 36 V or 60 V, enter the correct system
voltage on this screen.
•
Battery bank capacity, in amp-hours.
Figure 2-16
Configuration Screens
Battery
Bank 1
Battery Type
Flooded
Battery Capacity
300Ah
Battery Voltage
48V
Содержание XW-MPPT60-150
