Mounting
975-0400-01-01
2–3
Mounting
The instructions in this chapter are applicable to the typical stand-alone
installation. Installation procedures will vary according to your specific
application. For special applications, consult a qualified electrician or your
Xantrex Certified Dealer.
If installing the XW SCC as part of an XW System, see the
XW Power System
Installation Guide
for additional information.
Choosing a Location
The XW SCC must be mounted vertically and installed indoors in a dry, protected
location away from flammable materials, sources of high temperature, moisture,
and vibration. The location must also be sheltered from direct sunlight, rain, snow,
and wind-blown debris.
If using “sealed” batteries, the XW SCC can be mounted in the same enclosure as
long as it is adequately ventilated.
For optimal and safe operation, ensure there is adequate clearance around the XW
SCC. See Table 2-2 and Figure 2-1. If clearances are reduced below these
minimums, rated performance may not be achieved.
Important:
Installations must be compliant with all local electrical codes.
Installation
of this equipment should only be performed by a qualified electrician or by a Certified
Renewable Energy (RE) System installer.
CAUTION: Equipment damage
Never install the XW SCC where it is exposed to salt water spray. Exposure to salt water
will void the warranty and may cause a shock hazard.
WARNING: Explosion/corrosion hazard
To reduce the risk of fire or explosion, do not install the XW SCC in sealed compartments
containing batteries or in locations that require ignition-protected equipment.
To reduce the risk of corrosion from hydrogen-sulfide gas vented by batteries, do not
install the XW SCC in sealed compartments containing batteries.
Содержание XW-MPPT60-150
