56
Freedom SW Owner’s Guide
Configuring the Freedom SW using the SCP
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique identity
when several devices of the same type are installed in the power system
network. When each identical device has a unique number, the Xanbus SCP
can correctly identify and display status information for each device.
A device number consists of two digits ranging from 00 (default) to 31.
If only one of each type of device is installed in the network, you do not
need to set the device number. However, setting the device number to a
value other than 00 is recommended in case you need to use the
Restore Defaults
command (which resets the device number to 00).
After performing the command, checking that the device number has
returned to 00 indicates that the command was successfully completed.
To set the Freedom SW device number:
1.
On the Freedom SW Setup menu, select
Advanced Settings
.
If
Basic Settings
appears instead of
Advanced Settings
on the
Setup
menu, display
Advanced Settings
by pressing
Enter
+ Up arrow + Down arrow simultaneously.
On the
Advanced Settings
menu, select
Stacking
and press
Enter
.
2.
On the
Stacking
menu, select
Dev Number
.
3.
Press
Enter
to highlight the instance number.
4.
Use the up and down arrow buttons to adjust the two-digit identifier
number.
5.
Press
Enter
.
Figure 30
Setting a Device Number
FSW3012 00: Stacking
[00]
[01]
[1Ph Master]
Dev Name
Dev Number
Stack Mode
FSW3012 00: Stacking
Dev Name
Dev Number
Stack Mode
[00]
[*01]
[1Ph Master]
FSW3012 00: Stacking
[00]
[01]
[1Ph Master]
Dev Name
Dev Number
Stack Mode
3
5
4
Steps 1 and 2 are not shown.
Freedom SW 3K2K InvChg Owners Guide.book Page 56 Wednesday, October 9, 2013 1:34 PM
Содержание Freedom SW 815-2024
Страница 2: ...Freedom SW 3K2K InvChg Owners Guide book Page ii Wednesday October 9 2013 1 34 PM ...
Страница 14: ...Freedom SW 3K2K InvChg Owners Guide book Page iv Wednesday October 9 2013 1 34 PM ...
Страница 95: ...Freedom SW 3K2K InvChg Owners Guide book Page i Wednesday October 9 2013 1 34 PM ...