10
TD_PCM1x_Packages_Installation_09.04_GB
3.4 Installation
For installation into a panel door please proceed as follows:
1.
Panel cut-out
Cut out the panel according to the dimensions in Figure 3-1.
b
h H
B
2.
Insert control into cut-out
Insert the control into the panel cut-out. Verify that the control fits correctly in
the cut-out. If the panel cut-out is not big enough, enlarge it accordingly.
Move housing into panel
a)
Attach clamp here
3.
Attach mounting clamps
Rotate clamps according to the picture on the right until they snap into the
mounting cones.
b)
Rotate clamp until front
nut of the clamp locks into
front cone
4.
Screw clamps
Tighten the screw clamps until the housing is pressed and fixed against the
panel. Be careful not to over tighten the clamps which can unsnap the frame
from the housing. If this happens remove the control from the panel and reat-
tach the frame by pressing firmly against the housing.
Screw down until the
housing fits into
the panel
Note:
Using the gasket kit increases the IP protection from IP42 to IP54 from front. Mounting of the gasket is described in the
manual supplied with the gasket kit.