40
Step 2
,
Select “PTZ speed”, it is “Middle” by default.
The system will make the PTZ rotate with the speed you just set.
3.3.2.7 Idle Motion
Idle motion means the device implementing the behavior which is set in advance when it is not receiving any valid
command within the set time.
Note
: It needs to set preset, tour, scan and pattern in advance.
Step 1
,
Select “Setup > PTZ Settings > Function > Idle Motion”.
The system will display the interface of “Idle Motion”, which is shown in Figure 3.3-8:
Figure 3.3-8 Idle Motion
Step 2
, Check
“Enable” to enable idle motion function.
Step 3
, Select types of idle motion, which are preset, tour, scan or pattern.
Step 4
, Select the number of idle motion.
Step 5
, Set the idle time of the selected motion.
Step 6
, Click
to complete config.
3.3.2.8 PowerUp
It means the motion which is auto operated by the device after it is powered up.
Note
: It needs to set preset, tour, scan and pattern in advance.
Step 1
,
Select “Setup > PTZ Settings > Function > PowerUp”, which is shown in Figure 3.3-9:
