29
Figure 3.2-6 Multicast
Step 2
,
Check “Enable” to enable multicast.
Step 3
, Input multicast address and port.
Step 4
, Click
to complete config.
3.2.1.7 IP Filter
It can set the users who are allowed to visit the device via IP filter.
●
Trusted Sites
:
It is to add the users’ IP/MAC which can log in the device. If the users check the trusted sites,
then only the users’ IP/MAC which is in the list can log in the device; if trusted sites in not checked, then there is
no restriction for the users who visit the device.
● Users are not allowed to set the device IP/MAC as trusted sites.
● MAC verification can be valid only when the device IP and PC’s IP are in the same LAN.
Step 1
,
Select “Setup > Network > General > IP Filter”. The system will display the interface of “IP Filter”, which is
shown in Figure 3.2-7:
Figure 3.2-7 IP Filter
Step 2
, Check corresponding check box to enable trusted sites and banned list.
● Check “Trusted Sites”, click it and add trusted sites.
Step 3
,
Click “Add IP/MAC”, and configure IP address info according to Table 3.2-4
Parameter
Description
IP Address
Input the IP address of host which is to be added.
IP Segment
Input the start address and end address of the segment which is to be added.
IPv4
IP address adopts IPv4 format, such as 192.108.1.120
IPv6
IP address adopts IPv6 format, such as aa:aa:aa:aa:aa:aa:aa:aa
MAC
Input the MAC address of host which is to be added.
Table 3.2-4 IP Filter Description
