35
图
3.2-16 ONVIF
Step 2
,
Set “Authentication” as “Enable”.
Step 3
, Click
to complete setting.
3.3 PTZ Settings
3.3.1 PTZ Protocol
3.3.1.1 PTZ Protocol
Step 1
,
Select “Setup > PTZ Settings > Protocol > PTZ Setting”.
The system
will display the interface of “Network PTZ”, which is shown in Figure 3.3-1:
Figure 3.3-1 PTZ Settings
Step 2
, Configure info of each parameter according to the actual needs; refer to Table 3.3-1 for more details:
Parameter
Description
Protocol
Set PTZ protocol, support PELCOD, PELCOP, SHINWOO, Hitachi.
Address
Set corresponding device address.
Note
: Make sure the address is the same as that of the device, otherwise it will fail to
control the device.
Baud Rate
Select the baud rate used by the device.
Data Bit
It is 8 by default.
Stop Bit
It is 1 by default.
Parity
It is none by default.
Table 3.3-1 PTZ Parameter Description
