Winter MULTIMAX 300, Руководство по эксплуатации, Страница: 24 / 74

MUL TIMAX 300
Chapter 3: OPERATION
18
3-2 INSTALLING AND REMOVING BLADES
There are 2 methods to install or replace the saw blades of the sleeve on the arbor:
1. When saw sleeve is not fixed on the saw arbor:
(1) Stand the saw sleeve on the table, then put on proper spacers & saw blades
according the cutting-size requested. Be sure to clean the both sides of
spacers & saw blades before you put them on the sleeve. Also! Make certain
that the saw blades are in the same diameter and installed with the saw teeth
pointing in the same direction (as the figure shown below), then tighten the
locknut of the saw sleeve.
(2) Clean the contact faces of saw sleeve and saw arbor, the inner side of the
sleeve and the surface of the saw arbor by clean cloth. Any wood chips or
foreign substances (objects) sticks on them will cause sway and vibration
when the saw blades are running. These sway and vibration will make the
sawn wood not precise. Further more cause the defect of machines accuracy.
(3) Turn upward the lock pin of the saw arbor lifting handle and set it to the
position of releasing the handle. Raise the saw arbor to the limit by turning
the saw arbor elevating handle in a clockwise direction. Then, set the lock
pin to the nearest hole to make the saw blade fix on the highest position.
Press the pressure rollers lower button to lower the pressure rollers in order
to get enough space for install saw blades and sleeve assembly on the saw
arbor.