Winter MULTIMAX 300, Руководство по эксплуатации

Страница: 26 / 74

M ULTIMAX 300
Chapter 3: OPERATION
20
2. When the saw sleeve is fixed on the saw arbor:
If the saw blades are stayed between the pressure plate, firstly you must lift up the
saw arbor and then lower the pressure rollers unit to make the saw blades leave
the pressure plate. The saw blades can then be taken out.
(1) Make the saw blades leave the pressure plate by following the step (3) of the
first method, then use the special saw arbor nut wrench, the special sleeve
nut wrench and saw arbor lock wrench to release the nuts of the saw arbor
and the saw sleeve. After that, the saw blades and spacers can be taken off.
(2) Before installing the new saw blades and spacers on the sleeve, make sure to
clean up the surfaces of them. Also, make certain that the saw blades are in
the same size and installed with sawteeth pointing in the same direction.
(3) Tighten the nuts of the saw sleeve and the saw arbor by following the step (5)
of the first method.
3-3 CHECKING SAFETY DEVICES
Make sure the power supply is turned on, and the emergent STOP buttons are not be
pressed (as indicated by the arrows).