Winter MULTIMAX 300, Руководство по эксплуатации

Страница: 20 / 74

MULTIMAX 300
Chapter 2: INSTALLATION
14
2-3 FIXING THE MACHINE IN POSITION
1. PROPER LOCATION FOR THE MACHINE
◎
The floor must be able to support the machine's weight as well as the
vibrations produced when it is operating.
◎
The direction of sawed wood coming out of the machine must not be facing
an area where people may be passing.
2. LEVELING THE MACHINE
Place a leveler on the worktop of the machine and adjust the height of the three
sets of foundation nuts under the machine until the offset between the X and Y
shafts and horizontal is less than 0.3mm/m. After completion of the leveling
process, be certain to re-tighten the foundation nuts.
2-4 POWER CONNECTION
The power source should be connected by a qualified electrician.
◎
All wiring must be conform to international safety guidelines, choose a most
suitable size of cable subject to the voltage and mounting motors.
◎
A suitable breaker should be installed in the cable that between the main power
supply and the machine so that the power supply to the machine may be turned off
when not in use.
◎
Check and confirm the machine is proper grounded while in use to protect
the operator from electric shock
.
(The machine MUST be with the grounding installation below 10
Ω
)