https://www.XPOtool.com
Item 63003
Page 9
The Tool Experts
01 2022
-1
Plugging in the sprayer
1. Check that the
ON/OFF
switch is in the
OFF
(O)
position.
2. Plug the power cord into an earthed outlet or
heavy-duty earthed extension cord. Plug in the ex-
tension cord. Refer to “Important electrical infor-
mation.”
Pressure relief procedure
Be sure to follow the “Pressure relief” procedure when shutting the unit off FOR ANY
PURPOSE. This procedure is used to relieve pressure from the spray hose.
1. Lock the spray gun off (see di-
rections above). Flip the
ON/OFF
switch to the
OFF
position.
2. Turn the
PRIME/SPRAY
knob
to
PRIME.
3. Unlock the spray gun and trig-
ger spray gun into the side of the
material bucket. Re-lock the
spray gun.
Purging and priming the sprayer
All new units are performance-tested at the factory and are shipped with test fluid in the fluid section to
prevent corrosion during shipment and storage. If you have already used your pump, some water or
solvent used in cleaning may remain in the fluid section. Whether your sprayer is new or you have
already used it, this fluid must be purged and thoroughly cleaned out of the system prior to use. Follow
the steps below: