https://www.XPOtool.com
Item 63003
Page 6
The Tool Experts
01 2022
-1
Earthing instructions
This product must be earthed. In the event of an electrical short circuit, earthing reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having an earthing wire with an appropriate earthing plug. The plug must be plugged into an outlet that
is properly installed and earthed in accordance with all local codes and ordinances.
DANGER:
Improper installation of the earthing plug can result in a risk of elec-
tric shock.
If repair or replacement of the cord or plug is necessary, do not connect the green earthing wire to either
flat blade terminal. The wire with insulation having a green outer surface with or without yellow stripes
is the earthing wire and must be connected to the earthing pin.
Check with a qualified electrician or serviceman if the earthing instructions are not completely under-
stood, or if you are in doubt whether the product is properly earthed. Do not modify the plug provided. If
the plug does not fit the outlet, have the proper outlet installed by a qualified electrician.
This product is for use on a nominal 230
V circuit and has an earthing plug that looks like the plug
illustrated below. Make sure that the product is connected to an outlet having the same configuration as
the plug.
No adapter should be used with this product.
Components and description
Components
The shipping carton for your painting system contains the following:
•
Suction tube and return tube
•
Separating Oil
•
Spray gun with filter
•
Spray tip assembly (see chart on next page)
•
¼″ diameter pressure hose
•
Instruction manual
Controls and functions
•
ON/OFF switch
The ON/OFF switch turns the power to the sprayer on and off (O = OFF, l = ON).
•
Suction tube
Fluid is drawn through the suction tube into the pump.
•
Fluid section
A piston in the fluid section moves up and down to create the suction that draws fluid through
the suction tube.
•
Spray gun
The spray gun controls the delivery of the fluid being pumped. The gun model you have depends
on your sprayer model.
•
Spray hose
The spray hose connects the gun to the pump.
•
Return tube
Fluid is sent back out through the return tube to the original container when PRIME/SPRAY
knob is in PRIME position.
•
PRIME/SPRAY knob
The PRIME/SPRAY knob directs fluid to the spray hose when set to SPRAY or the return tube
when set to PRIME. The arrows on the PRIME/SPRAY knob shows the rotation directions for
