Wilo Yonos GIGA-N 125-5,5, Инструкция по установке и эксплуатации

Страница: 48 / 80

en Operation
48 WILO SE 2020-10
No. Designation Type Symbol Values/explanations Display conditions
Constant speed control
Constant Δp-c control
PID-Control
2.3.2.0
Δp-v gradient Setting gradient of Δp-v (value in %) Not displayed for all pump types
3.0.0.0
Pump on/off
±
ON
Pump switched on
OFF Pump switched off
4.0.0.0
Information Information menus
4.1.0.0
Actual values Display of current actual values
4.1.1.0
Actual values
sensor (In1) Depending on current control mode.
Δp-c, Δp-v: Value H in m
PID-Control: Value in % Not displayed for constant speed
4.1.3.0
Power Current power input P
1
in W
4.2.0.0
Operating data Display of operating data The operating data refer to the
electronic module currently being
operated
4.2.1.0
Operating hours The pump's total active operating hours
(counter can be reset via infrared inter-
face)
4.2.2.0
Consumption Energy consumption in kWh/MWh
4.2.3.0
Pump cycling
countdown Time to pump cycling in hours (at a resolu-
tion of 0.1 h) Shown only for twin-head pump
master and internal pump cycling.
Can be set in the service menu
<5.1.3.0>
4.2.4.0
Remaining time
until pump kick Time until the next pump kick (after the
pump has had a 24-hour standstill, e.g. via
“External off”, it will be automatically op-
erated for 5 seconds) Only displayed if pump kick is ac-
tivated
4.2.5.0
“Mains on”
counter Number of times the supply voltage is
switched on (each occasion the supply
voltage is established after an interruption
is counted)
4.2.6.0
Pump kick
counter Number of pump kicks carried out Only displayed if pump kick is ac-
tivated
4.3.0.0
Statuses
4.3.1.0
Base-load pump The value display shows the identity of the
regular base-load pump statically. The
units display shows the identity of the
temporary base-load pump statically. Only displayed for twin-head pump
master
4.3.2.0
SSM ON
Status of SSM relay if a fault message is
present