Wilo Yonos GIGA-N 125-5,5, Инструкция по установке и эксплуатации

Страница: 41 / 80

Operation en
Installation and operating instructions Wilo-Yonos GIGA-N 41
The following symbols are used to simplify the display of menu elements or actions:
8.4.1 Menu elements
12.3
ƒ
Menu status page: standard view on the display.
4.1.0.0
ƒ
“One level down”: A menu element with subordinate menu levels which you can
switch to (e.g. <4.1.0.0> to <4.1.1.0>).
4.4.3.0
ƒ
“Information”: A menu element with information about the device status or settings
that cannot be changed.
2.0.0.0
±
ƒ
“Selection/setting”: A menu element that provides access to a changeable setting
(element with menu number <X.X.X.0>).
ƒ
“Level up”: A menu element with superordinate menu levels which you can switch
to (e.g. <4.1.0.0> in <4.0.0.0>).
E000
ƒ
Menu error page: In case of a fault, the current error number is displayed instead of
a status page.
8.4.2 Actions
ƒ
Turn the operating button: Turn the operating button to increase or decrease set-
tings or menu numbers.
ƒ
Press the operating button: Press the operating button to activate a menu element
or confirm a change.
ƒ
Navigate: Follow the instructions below to navigate until the displayed menu num-
ber is reached.
ƒ
Wait time: The remaining time (in seconds) is displayed until the next state is
reached automatically or a manual input can be made.
ON
X
ƒ
Set DIP switch to “OFF” position: Set DIP switch number “X” under the housing
cover to the “OFF” position.
ON
X
ƒ
Set DIP switch to “ON” position: Set DIP switch number “X” under the housing
cover to the “ON” position.
8.5 Display modes
Display test
max
max
min
min
2
2
Fig. 36: Display test
As soon as the electronic module has been supplied with power, a 2-second display test
is carried out. All characters of the display are shown. Then the status page appears.
After interruption of the power supply, the electronic module carries out various shut-
off functions. The display will be shown for as long as this process continues.
DANGER
Risk of fatal injury due to electrical current! Electrical charge may still be
present even if the display is switched off.
Coming into contact with live parts will result in death or serious injuries!
• Before working on the pump, disconnect the supply voltage and wait for
5 minutes.
• Check whether all connections (including potential-free contacts) are voltage-
free.
• Never poke around in the openings on the electronic module and never insert
anything into it!