Will Burt Inflexion Plus 1.8, Руководство по эксплуатации

Страница: 57 / 104

PAGE 55 OF 102
INFLEXION PLUS
OPERATING INSTRUCTIONS
TP-5211901-C
JUNE 2021
Two common operator errors can occur when the operator does not use the Auto-Up feature:
1. On uneven ground, an operator may believe the mast has reached 90° and release the "Mast
Up" button too early. This could cause an error when the operator wants to use certain
controller functions since the mast must be at 90° to perform these actions.
2. During high winds, if an operator stops the mast before it is firmly seated at 90°, the mast
may initially be at 90°, but be pushed off of 90° by the high winds. This could cause an error
when the operator wants to use certain controller functions since the mast must be at 90° to
perform these actions.
When using the "Mast Up" button, press the button until the software stops the mast in order to
ensure the mast has reached 90°.
6.7.1 Using the Auto-Up Feature
The Auto-Up sequence can be aborted by pushing any of the buttons on the controller at any
point during the Auto-Up sequence. If the Auto-Up sequence is aborted, the mast will stop and
wait for input from the controller. "Auto-Up" will be shown on the controller, and after the mast
leaves the stowed position and begins moving toward 90° (takes about 2 seconds), the controller
"Mast Down" and "Mast Up" LEDs will light.
To raise the mast to 90° using the Auto-Up feature, press the "Mast Up" button twice quickly in
successive depressions (two depressions within a ½ second). The mast will raise to 90°. The
mast will not extend upward by itself, but will await further operator input from the controller.
6.7.2 Using the Mast Up Button
Raise the mast to 90° using the "Mast Up" button as follows:
1. Press and hold "Mast Up" until the mast is at 90°. Press the button until the software stops
the mast to ensure 90° has been reached.
2. Release "Mast Up" button when the additional controller LEDs like "Tilt Down" and "Pan
Right" light. The lighting of the LED indicators indicate the mast has reached 90°.
6.8 Extending the Mast
After reaching 90°, the mast can be extended to full or partial height. To extend the mast when it
is at 90°, press and hold "Mast Up" until the mast reaches the desired height.
Pushing "Mast Up" button will cause the mast to rise until the "Mast Up" button is released, or the
mast reaches its maximum extended height. If the "Mast Up" button is not released, the mast will
reach its fully extended height, the air pressure will rise to 20 psi (1.4 bar), and then the exhaust
valve will open and exhaust any more air that enters the mast, leaving the mast at its maximum
extended height.