Will Burt Inflexion Plus 1.8, Руководство по эксплуатации, Страница: 35 / 104

PAGE 33 OF 102
INFLEXION PLUS
OPERATING INSTRUCTIONS
TP-5211901-C
JUNE 2021
3. Ensure all components are included and that the required tools are readily available. The
components in the system shipment are shown in Table 5-2.
*The labels from the label kit can be applied where the operator deems appropriate in site of
the operating station.
**The 6 mm wrench is used to emergency stow the mast. If necessary, it can also be used in
conjunction with the 1.5 mm wrench to assist in disassembling the actuator. Contact The Will-
Burt Company’s Service for detailed instructions on this process.
4. Inspect for any shipping damage. If damage has occurred, notify the carrier.
5. Unbolt (for wooden crates) and remove any banding fixing the mast to the shipping crate or
carton. Remove any banding fixing the mast.
6. Using a hoist, lift the unit from the shipping container by the mast tube at the labeled center of
gravity symbol (Figure 5-2) position. Lifting from locations other than those indicated could
result in equipment damage. Use two point contact for slings to keep the load stable while
moving.
Figure 5-2 Center of Gravity Symbol
Table 5-2 Components in the System Ship
Base Assembly DC Board Power
Cable
Exhaust Hose Controller (Selected
from the following):
• HHRC with
Bulkhead
• PMRC
• WHHRC
Supply Air Hose Ferrite Label Kit* Wrench, HEX L-Key 6
mm** (Models 4.5, 6.0,
and 7.5)
Wrench, HEX L-
Key 1.5 mm
(Models 4.5, 6.0,
and 7.5)
Operator’s Manual
on CD
D-TEC II (Optional) Nycoil (Optional)
Drawings of your
system to assist in
the installation
process
Inflexion Plus with
PositionIt™ PI-35:
• PositionIt™ PI-35
• Bulkhead Control
Cable
Inflexion Plus with
PositionIt™ PI-75:
• PositionIt™ PI-75
• Bulkhead Control
Cable