Will Burt Inflexion Plus 1.8, Руководство по эксплуатации

Страница: 55 / 104

PAGE 53 OF 102
INFLEXION PLUS
OPERATING INSTRUCTIONS
TP-5211901-C
JUNE 2021
6.5 Quick Operation Summary
Following is a quick summary of the operation of the system. Detailed steps follow the quick
summary.
If an emergency stop (E-Stop) is required at any time, press the “E-Stop” button. This will
disconnect the unit from power and cause all air to be exhausted from the mast. The mast will
fully lower (if it was raised) regardless of the orientation of the payload, but not tilt.
1. Ensure the vehicle is stationary and the parking brake is engaged.
2. Ensure there are no obstructions in the mast operating space.
3. If the “E-Stop” was activated, it must be reset by turning to enable the system to power-up.
Do not reset the “E-Stop” until the cause of the event is corrected. Turn the red “E-Stop”
button if needed. Then press "NFPA Start" to power-up the mast.
4. Raise the mast to 90° by performing one of the following steps:
• Quickly press "Mast Up" twice (Auto-Up feature) to move mast to 90°. To abort the Auto-Up
feature, press any controller button.
• Press and hold "Mast Up" to raise the mast. Only the controller buttons that have a lit LED are
active.
5. If desired, raise the mast further by pressing "Mast Up".
6. Position the payload vertically by pressing "Tilt Down" and "Tilt Up".
7. Position the payload horizontally by pressing "Pan Right" and "Pan Left".
8. If desired, lower the mast by pressing "Mast Down".
9. Stow the mast by performing one of the following steps:
• Quickly press "Mast Down" twice (Auto Stow® feature). It is recommended to use the Auto
Stow® feature to stow the mast. To abort Auto Stow®, press any controller button.
• Press and hold "Mast Down" until all LEDs on the controller turn off. Ensure that "Mast Down"
is released only after the controller LEDs turn off which means the mast is stowed.