Wieland wienet v3, Руководство пользователя

Страница: 89 / 95

Configuration in Typ. Situations
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
90
LAN
configuration In the
LAN
item –
Primary LAN
– you can leave the factory default configuration as in
the previous situation. The ETH1 interface on the front panel of the router is used for connection to the
Internet. It can be configured in Secondary
LAN . Connect the cable to the router and set appropriate val-
ues as in the fig. 85 – here static IP address, default gateway and DNS server are configured. Changes
will take effect clicking on the
Apply
button. Detailed configuration of
LAN
is described in the 4.1 chap-
ter.
WLAN
and
WiFi
configuration It’s necessary to enable wlan0 network interface in the
WLAN
item, see
fig. 86. Check the
Enable WLAN
interface, set the
Operating Mode to station (STA),
enable the DHCP cli-
ent and fill in the default gateway and DNS server for accessing the Internet. Click the Apply button to
confirm the changes. For details see chapter 4.6.
Configure connection to a WiFi network in the WiFi item, see fig. 87. Here check the
Enable WiFi
and fill
in the data for connection (
SSID
, security, password) and confirm clicking the
Apply
button. For detailed
configuration see 4.5 chapter.
To verify successful WiFi connection, see Status section,
WiFi
item.
There will be
wpa_state=COMPLETED
written out if connected successfully.
Backed up access to the Internet –
WLAN
configuration
Mobile
WAN
configuration To configure the mobile connection it is sufficient to insert the SIM card into
the SIM1 slot and attach the antenna to the ANT connector as in previous situation (depending on used
SIM card). For using the system of backup routes it’s necessary to enable check of connection in the
Mo-
bile WAN
item, see fig.. Set the
Check connection option to e bind
and fill in an IP adress of e.g.
operator’s DNS server or any other surely available server and time interval of the check. For detailed
configuration see chapter 4.3.1.