Wieland wienet v3, Руководство пользователя

Страница: 9 / 95

Status
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
10
4 Status
4.1 General Status
A summary of basic information about the router and its activities can be invoked by selecting the Gen-
eral item. This page is also displayed when you login to the web interface. Information is divided into a
separate blocks according to the type of router activity or the properties area –
Mobile Connection, Pri-
mary LAN, Secondary LAN, Peripherals Ports and System Information
. If the router is a SWITCH or
RS232-RS485-ETH version, there will be displayed a tertiary
LAN
block. If the router is WiFi equipped,
there will be a WiFi block displayed, too.
4.1.1 Mobile Connection
Item Description
SIM Card Identification of the SIM card
(Primary or Secondary)
Interface Defines the interface
Flags Displays network interface flags
IP Address IP address of the interface
MTU Maximum packet size that the equipment is able to transmit
Rx Data Total number of received bytes
Rx Packets Received packets
Rx Errors Erroneous received packets
Rx Dropped Dropped received packets
Rx Overruns Lost received packets because of overload
Tx Data Total number of sent bytes
Tx Packets Sent packets
Tx Errors Erroneous sent packets
Tx Dropped Dropped sent packets
Tx Overruns Lost sent packets because of overload
Uptime Indicates how long the connection to mob. network is established
4.1.2 Primary LAN, Secondary LAN, Tertiary LAN, WiFi
Items displayed in this part have the same meaning as items in the previous part. Moreover, the MAC
Address item shows the
MAC address
of the corresponding router’s interface
(Primary LAN – eth0, Sec-
ondary LAN – eth1, Tertiary LAN – eth2, WiFi – wlan0).
Visible information depends on configuration (see
4.1 or 4.5). If the router is equipped with PoE PSE board, additional information can be found in the
Pri-
mary LAN or Secondary LAN
section (see table below for description).
Item Description
PoE PSE Status •
Disabled – PoE PSE is disabled in the Primary LAN or Secondary LAN con-
figuration form.
•
Undervoltage – Undervoltage, i.e. a lower voltage than the nominal operat-
ing voltage.
•
Overcurrent – Overcurrent, i.e. a higher current than the permissible posi-
tive difference of the nominal current.
•
Idle – PoE PSE is enabled, but currently not used.
•
Class 0 – Power level (classification unimplemented)
•
Class 1 – Power level (very low power)
•
Class 2 – Power level (low power)
•
Class 3 – Power level (mid power)
•
Class 4 – Power level (high power)
PoE PSE Power Power of PoE PSE [W]
PoE PSE Voltage Voltage of PoE PSE [V]
PoE PSE Current Current of PoE PSE [mA]
PoE PSE information