Wieland wienet v3, Руководство пользователя

Страница: 20 / 95

Contents of Package
21
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
5 Contents of Package
5.1 LAN Configuration
Select the
LAN
menu item to enter the network configuration for the Ethernet ports.
Primary
subi-
tem is intended for the first ETH router’s interface (ETH0),
Secondary
is for the second ETH router’s
interface (ETH1).
Tertiary LAN
is for the SWITCH (3x Ethernet) or RS232- RS485-ETH expansion port
if installed, it is the ETH2 interface.
Item Description
DHCP Client •
disabled – The router does not allow automatic allocation IP address
from a DHCP server in LAN network.
•
enabled – The router allows automatic allocation IP address from a
DHCP server in LAN network.
IP address Fixed set IP address of network interface ETH.
Subnet Mask IP address of Subnet Mask.
Bridged •
no – router is not used as a bridge (default)
•
yes – router is used as a bridge
Media type •
Auto-negation – The router automatically sets the best speed and
duplex mode of communication according to the network’s possibil-
ities.
•
100 Mbps Full Duplex – The router communicates at 100 Mbps, in
the full duplex mode.
•
100 Mbps Half Duplex – The router communicates at 100 Mbps, in
the half duplex mode.
•
10 Mbps Full Duplex – The router communicates at 10 Mbps, in
the full duplex mode.
•
10 Mbps Half Duplex – The router communicates at 10 Mbps, in
the half duplex mode.
PoE PSE •
enabled – The router provides power on the Ethernet cable
•
disabled – The router does not provide power on the Ethernet cable
(default)
Default Gateway IP address of router default gateway. If filled in, all packets not fitting
the route table rules would have been sent to this adress.
DNS server IP address of DNS server of the router. All the DNS queries are for-
warded to this address.
Configuration of the Network Interface
The
Default Gateway
and
DNS Server
items are only used if the
DHCP Client
item is disabled, and if the
Primary or Secondary LAN is selected by the Backup Routes system as a default route. (The backup
routes selection algorithm is described in section
Backup Routes
). Since FW 5.3.0,
Default Gateway
and
DNS Server
are also supported on bridged interfaces (e.g. eth0 + eth1).
There can be only one active bridge on the router at a time. Only the parameters
DHCP Client, IP address
and
Subnet Mask
can be used to configure the bridge. The Primary LAN has the higher priority when
both interfaces (eth0, eth1) are added to the bridge. Other interfaces (wlan0 – wifi) can be added (or de-
leted) to (from) an existing bridge at any time. Moreover, the bridge can be created on demand for such
interfaces but not configured by their respective parameters.
The DHCP server assigns the IP address, default gateway IP address, and IP address of the DNS server to
the connected DHCP clients. If these values are filled-in by the user in the configuration form, they are
preferred.