Wieland wienet v3, Руководство пользователя

Страница: 15 / 95

Status
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
16
4.5 Network Status
To view system information about the router operation, select the
Network
item in the
Status
menu. The
upper part of the window displays detailed information about active interfaces:
Item Description
eth0, eth1, eth2 Network interfaces (ethernet connection)
usb0 Active PPP connection to the mobile network – wireless module is
connected via USB interface
wlan0 WiFi interface
ppp0 PPP interface (e.g. PPPoE tunnel)
tun0 OpenVPN tunnel interface
ipsec0 IPSec tunnel interface
gre1 GRE tunnel interface
lo Local loopback interface
Description of the interface in network status
Each of the interfaces shows the following information:
Item Description
HWaddr Hardware (unique) address of networks interface
inet IP address of interface
P-t-P IP address second ends connection
Bcast Broadcast address
Mask Mask of network
MTU Maximum packet size that the equipment is able to transmit
Metric Number of routers, over which packet must go trought
RX •
packets – received packets
•
errors – number of errors
•
dropped – dropped packets
•
overruns – incoming packets lost because of overload
•
frame – wrong incoming packets because of incorrect packet size
TX •
packets – transmit packets
•
errors – number of errors
•
dropped – dropped packets
•
overruns – outgoing packets lost because of overload
•
carrier – wrong outgoing packets with errors resulting from the
physical layer
collisions Number of collisions on physical layer
txqueuelen Length of front network device
RX bytes Total number of received bytes
TX bytes Total number of transmitted bytes
Description of Information in Network Status
It is possible to read status of connection to mobile network from the network information.
If the connection to the mobile network is active, it will be shown in the system information as an usb0
interface. At the bottom, there is the Route Table displayed.