030-300408 Rev. B
95
August 2005
VersaLink™ Gateway (Model 327W)
User Guide
To enable VLAN click on the box adjacent to the
VLAN Enable
field. A check mark will appear in the box.
Click on
save.
NOTE: For VLAN to function properly, the VLAN ID must be set to a value other than ‘1’ in
VLAN
Configuration
screen and in the
VC 1 Configuration
screen when the you are using the Bridge (VLAN Bridge)
protocol. See Advanced WAN section for configuring VC’s (refer to section 13.6.5).
NOTE: If you change the values in the
VLAN Configuration
screen and click the
reset
button, the screen will
display the previously set values for the LAN Port you have selected. If you change the settings in this screen, you
must click
save
to save the new settings.
If you click on
save
, the following pop-up screen will appear. Click
OK
in the pop-up screen to allow the new
settings to take effect.
